1992 Ford Laser

[twinturbo]

I recently looked at your products available for the KH Laser TX3. I have a non TX3 laser and would like to know if the suspension, apart from springs and dampers, are the same as the regular laser so that I could fit the suspension kit available for TX3's on my car. An indication of wether this is possible, not possible or if other changes will be needed will be appreciated. Thanks

P.S My car is a non TX3 1992 Ford KH Laser hatch

[twinturbo]

bump

[Peter]

G'day - sorry-about-that :(

The AWD TX3 chassis is different and the following parts are applicable to your FWD KH Laser.

Springs:
Front: 74601A
Rear: 71407A

Alignment
Front strut tower brace KSB606
Front camber adjusting bolt kit KCA412
Front caster anti-lift kit KCA324X
Rear camber adjusting bolt kit KCA412
Rear strut tower brace KSB537

Swaybars
Front 22mm fixed rate bar BTF32
Rear: 20mm fixed rate bar BFR46, or 22mm bar BFR46X

Cheers

Peter
peter@whitline.com.au

[twinturbo]

Cool thanks for the info, greatly appreciated