Mustang - whiteline rear swaybar

[C0V3R]

I bought a rear swaybar kit a fair while ago for my 68, however it didnt come with all the hardware needed to fit it. It came with the U shaped chassis mounts (I think) similar to the front bar, but it didnt have any sort of end links/etc. As the car didnt come with a rear bar I'm not quite sure how it should go in or where to mount the end links.

Could you give me a part number for the end links and rubbers as well as a rough idea about the orientation of the mount setup?

Thanks.

[Whiteline]

Hi COV3R,

Thanks for your post.

It sounds like have a BFR41. This is listed as a "replacement" type swaybar the "replaces the original swaybar. If your car does not have an original swaybar, the BFR41 will not fit.

We suggest that you try a BFR1.

Hope that this helps.

Cheers
Bob

[C0V3R]

Is the design different or is the kit just missing some pieces? Can I just get the missing pieces?

The BFR41 is listed at 20mm vs the BFR1 at 18mm

[Whiteline]

These are totally different in design and are not interchangable.
the BFR41 is 20mm as this is replacing an existing swaybar that is part of the designed suspension package out of the factory. The increase here is about 40%.

The BFR1 is fitting a new swaybar to a car that has no swaybar. Affective increase of this is far greater than 40%.

cheers
Bob