Anyone used W/L front camber bolts before? KCA414

[d_ten]

hi,
just bought some Whiteline camber bolts for my S14 silvia, front camber bolts part numbered KCA414.

i found them really hard to put it, looks like the lobe is a lil too big for the hole on the hubs. any one exprienced this problem? i have measured they are 14mm, but there's no way so just slide them in like factory bolts...

any ideas? i was planning to use 2 sets for drift use, now since they are so hard to put in i've only put in one set.

also the KCA414, what other cars can they be used on except the Nissan Silvia S14/15?


thanks.

[allwaysideways]

hi i have trial fitted some 415 camber bolts and they too were tricky to get all the way in, much longer too!

haven't had it set up as yet...
watch this space :-)

[allwaysideways]

sorry these 415 bolts are for the celica

[Wojtek]

Hi,
KCA414 is the correct camber kit for your car, which we use and fit to these cars all the time. The design of this product dictates a tight fit of the bolt (cam of the bolt) within the hole in the hub. Care must be taken to clean the holes and bolts, loosen the bottom bolt and make sure that the top holes in the strut and the hub exactly line up.
We do recommend not to use 2 camber bolts on the same strut.
Wojtek.

[d_ten]

Originally posted by Wojtek
We do recommend not to use 2 camber bolts on the same strut.
Wojtek.

why is that? thanks.

[Wojtek]

There should always be at least 1 plain bolt to act as a pivot and then just 1 eccentric bolt to adjut camber. Using 2 adjusters on 1 hub/strut greatly increases the chances of sliping/moving.

Wojtek.

[d_ten]

Anyone know what other car models will fit the KCA414 except the S14/15??

[Wojtek]

d_ten,

Too many to list. What car are you inquiring in particular?

Wojtek.

[d_ten]

Do you know if Any skyline series will fit?

R33 or R34?

thanks.

[Peter]

G'day d_ten,

The R Series Skyline front end uses an upper and lower control arm and is therefore not a strut suspension and does not have a clevis as on the S Series chassis.

Camber can be adjusted on the R33 and R34 front end using Upper Control Arm Camber Adjusting Kit KCA348.

Regards

Peter
peter@whiteline.com.au

[d_ten]

Thanks Peter
I am still after a list of cars that the 414 will fit, can you give me a list please? Except the S14 and S15.

thanks.

[Wojtek]

Hi d_ten,

There are many cars that use our KCA414 camber kits. If you still need to know a full list of cars these are used for except S14 and S15, you are welcome to refer to our Alignment Catalogue. Here is a link to a copy;
http://www.whiteline.com.au/docs/catalogues/WLA02g_full.pdf

Regards,
Wojtek.